Difference between revisions of "Georeferencing Parameters"
From DGIWG
| Line 1: | Line 1: | ||
| − | |||
The properties of Georeferencing Parameters are listed below. The intent is not to enable geopositionning of pixel but to enable discovery of imagery data, on the basis on acquisition information. | The properties of Georeferencing Parameters are listed below. The intent is not to enable geopositionning of pixel but to enable discovery of imagery data, on the basis on acquisition information. | ||
Latest revision as of 13:25, 18 October 2018
The properties of Georeferencing Parameters are listed below. The intent is not to enable geopositionning of pixel but to enable discovery of imagery data, on the basis on acquisition information.
| Identifier | Title / Description | Value Domain | Card |
|---|---|---|---|
| azimuth
[DMF/Sensor]
|
Instrument Azimuth
Horizontal angle to the measuring instrument counted counterclockwise from North (source ISO 19159-1). It is expressed in decimal degrees.
Note: This angle should be measured at the center of the image.
Constraints: * mandatory for radar
|
Float
0…360
|
0..1 |
| elevationAngle
[DMF/Sensor]
|
Instrument Elevation
Elevation angle between the horizontal plane and the line of sight, measured in the vertical plane.
Note: This angle should be measured at the center of the image.
Constraints: * mandatory for radar
|
Float
-90..90
|
0..1 |
| sensLat
[DMF/Sensor]
|
Sensor latitude
Sensor latitude in WGS84 horizontal datum, expressed in decimal degrees.
|
Float
-90…+90
|
0..1 |
| sensLong
[DMF/Sensor]
|
Sensor longitude
Sensor longitude in WGS84 horizontal datum, expressed in decimal degrees.
|
Float
-180…+180
|
0..1 |
| sensHeight
[DMF/Sensor]
|
Sensor height
Sensor height above WGS84 ellipsoid, expressed in meters.
|
Float | 0..1 |
| geoposModelType
[DMF/Sensor]
|
Geopositioning Model Type
Type of geopositioning model.
|
Geopositioning Model Type Codelist | 1 |
| calFocalLength
[DMF/Sensor]
|
Calibrated Focal Length
Distance between the perspective centre and the image plane that is the result of balancing positive and negative radial lens distortions during sensor calibration (source ISO 19130). It is expressed in millimeters. Constraints: * Only applicable to electro optical sensors
|
Float | 0..1 |
| horFoV
[DMF/Sensor]
|
Horizontal field of view
Instantaneous region seen by a sensor, provided in angular measure (source ISO 19130-2).
|
Float | 0..1
|
